Checkline MTM Manual de usuario descargar pdf (Pagina 13)

AWS-MTM-DP Guide

PROGRAMMING

FULL

SCALE

This screen shows the Full Scale value of the Torque Shaft. This is not a field adjustable

value.

LOW LIMIT

Use the low limit setting as a means of visually flagging the operator when a reading fails

to reach a desired minimum value. A small down arrow will appear on the screen is a

peak is captured below the limit setting.

The limit is adjusted by using the navigation buttons to set the first four digits to the

desired value. The fifth digit is used to select the decimal point position. The up and

down buttons under the “Soft” button

Change will change the value from 0-9. Pressing

the “soft”

DIG will scroll through the digit positions. When the correct value is entered,

pressing the

ENT button will return you to the menu system.

Once all the digits have been set, press the MEM key to accept the value and return to

Program Function mode. The next time a reading is taken, "LO" will appear on the

display if the captured value is less than the low limit

HIGH LIMIT

Use the high limit setting as a means of visually flagging the operator when a reading

falls over a desired maximum value.

High limits are set in the identical way as low limits. Please refer to the Low Limit section

for details.

NOTE ON LIMITS: The green LED on the front of the display will flash when a peak is

captured that falls within the limit setting.

SLEEP MODE

To conserve battery life, the MTMDP is equipped with a "sleep" mode, which sets the unit

to standby after a user-settable amount of time has passed without activity.

Press the + key to increase the number of minutes the unit will wait for input, or press

the - key to decrease the number. This example shows a value of four minutes.

The highest possible sleep setting is 20 minutes. Press ENT to accept the value and

continue to the next function.

1 2 ... 8 9 10 11 12 13 14

Sin comentarios

Checkline MTM Manual de usuario Pagina 13