Checkline RTM 20D Manual de usuario descargar pdf (Pagina 9)

6:1:2 ZERO

When installed on the competely slack rope, the RTM should indicate zero on the dis-

play otherwise you have to zeroize the instrument. When you set to zero hold the RTM

with the tightning device hanging vertically or put the RTM in this position on a slack

rope.

The instrument is zeroed by pressing and holding the

ENTER/ZERO for about 2 seconds.

The display will indicate

This zero-setting remains saved even if the RTM is turned off.

This zero-setting should only be done when the rope is untensioned.

6:1:3 Peak Value - highest displayed value

The instrument stores automaticly the highest displayed value. This peak-value can

originate from any of the different “Rope No”s.

This peak-value remains saved even if the RTM is turned off.

To display peak-value press and hold in the PEAK - button.

When the button is released the display will indicate the present tension value.

Do not forget to reset the Peak Value before doing new measurements.

To reset the peak-value, do the following:

PEAK +

ENTER/ZERO i.e.

press and hold in the PEAK button

press the

ENTER/ZERO button too

release the

ENTER/ZERO and PEAK buttons.

The peak value is also resetted if the instrument is set to zero.

8(12)

RTM 20 D - Users Manual BA 7047be

ba7047be.vp - 040216

PEAK

000

ENTER

ZERO

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Checkline RTM 20D Manual de usuario Pagina 9